Exit Roller Unit - Brother HL-6050 Service Manual

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
3.13

Exit Roller Unit

(1) Disconnect the connector "A" from the relay PCB L ASSY.
(2) Disconnect the connector "B" from the relay PCB R ASSY.
(3) Remove the two cup S M3x6 Taptite screws, and remove the exit roll unit.
Relay PCB L ASSY
(4) Release the two hooks, and remove the document cover sensor.
(5) Disconnect the connector.
Document cover sensor
Taptite, cup S M3x6
Exit roll unit
Connector
Connector "B"
Fig. 4-31
Exit roller unit
Fig. 4-32
4-18
Taptite, cup S M3x6
Connector "A"
Relay PCB R ASSY
Hook
Hook