Brother HL-6050 Service Manual page 43

Reprint the last job 3 times
1. Set the REPRINT setting is ON by using the control panel buttons to enter the SETUP
menu.
NOTE:
If you print with the driver we have supplied with the printer, the settings for Job Spooling in
the printer driver will take priority over the settings made on the control panel.
2. Press the Reprint switch.
COPIES=
Press + twice
COPIES=
Press the Set or Reprint switch.
PRINTING
COPIES= 1
NOTE:
1) If you press the Go button twice, the printer will leave the REPRINT setting.
2) If you want to reprint the data and have pressed the Go button, the display shows "
". Press the Set or Reprint button to start reprinting, or press Go again to
SET TO PRINT
cancel the reprint job.
(2) Printing SECURE data
Secure documents are password protected and only those people that know the
password will be able to print the document. The printer will not print the document when
you have sent it for printing, to print the document you must use the control panel of the
printer or connect to the printer using a web browser.
When you want to delete the spooled data, you can carry out this operation on the control
panel or in the web based management software.
NOTE:
•
If there is data in the job information that cannot be displayed on the LCD, the display
shows "?".
If you wait too long to continue the
1
control panel button operation, the display
leaves the REPRINT setting automatically.
3
2-11
HL-6050/6050D/6050DN SERVICE MANUAL
PRESS