Call Forwarding Off Premise; Feature Available - NEC DS1000 Release Notes

Call Forwarding Off Premise

Feature Available

DS1000 Release Notes
G
Press SPK to cancel Auto Redial.
G
Lift and replace the handset.
G
Press the CANCEL soft key (Super Display only).
If a Caller ID call rings while Auto Redial is enabled, your display will show the number
and optional name of the incoming caller. However, the ringing does not cancel Auto Redial.
In addition, the Auto Redial display will be restored after the Caller ID call stops ringing.
Off Premise Call Forwarding allows a keyset user to forward their calls to an off-site location (such
as a cell phone or remote office) if allowed by their Class of Service. Keyset users can stay in touch
by having Off Premise Call Forwarding automatically forward their calls while they are away from
the office. To set up Off Premise Call Forwarding, the user selects the trunk or trunk group over
which the call should route, as well as the number the system should dial. The number dialed can be
from an extension's Personal Speed Dial bin containing an outside number, or the user can enter an
outside number directly into their Personal Speed Dial bin 720. When a call rings the forwarded
extension, the system selects the specified trunk or group and then outdials the stored number.
Off Premise Call Forwarding reroutes:
G
Intercom calls
G
Transferred calls
G
Direct Inward Lines
G
UTRF (unscreened transfer) calls routed from the Voice Mail Automated Attendant
G
Circular and Terminal Extension Hunting calls
Off Premise Call Forwarding does not reroute:
G
Key Ring calls
G
Calls to a UCD Group master number.
G
Group Ring calls (i.e., calls to a Ring Group master number)
G
UCD Hunting Calls (i.e., calls to a UCD master number)
G
Ringing Call Coverage key calls
You can set up Off Premise Call Forwarding to reroute all calls or just trunk calls. If an extension
with forwarding set for trunk calls only receives a screened Transfer, the initial voice-announce-
ment broadcasts at the extension. When the caller hangs up to complete the transfer, the trunk call
forwards as programmed.
Notes:
G
Telco must provide Loop Disconnect Supervision on the originating trunk (i.e., the trunk
that Off Premise Call Forwarding will reroute).
G
All other Speed Dial programming also applies to Off Premise Call Forwarding.
G
An extension Speed Dial number stored in bin 719 should not be longer than 16 digits. If it is,
the system automatically clears bin 719 when it stores an Off Premise Call Forwarding num-
ber in bin 720.
G
An extension user cannot off premise call forward to a Personal Speed Dial bin that contains
an Intercom number. If the user selects a bin that contains an Intercom number, the system
cancels Off Premise Call Forwarding.
G
Off Premise Call Forwarding is cleared after a system reset or power down.
DS1000 02.10.09 Release Notes
New Features in 02.10.09
3 N 02.10.09