Checking The Customer Site; Copier Model; Power - Canon FY8-13HR-000 Service Manual

2 Checking the Customer Site

Before you install the iR-M1, check site conditions and inform the customer of any instal-
lation requirements.

2.1 Copier Model

I What copier model is installed?
I Is there space near the copier for the iR-M1?
Make sure there is space for the iR-M1. You may need to move the copier out from the
wall for easier access.
I Does the copier require service or adjustment?
Copy the copier test page before you install the iR-M1.
If the copied image indicates that the copier needs adjustment, inform the customer.
After getting approval, complete the copier service needed.

2.2 Power

I Is there a dedicated grounded electrical outlet near the copier for the iR-M1?
Locate the grounded electrical outlet that will supply power to the iR-M1. The iR-M1
and the copier should not run on the same circuit. Use a surge suppressor for the iR-M1.
• Do not use a 3-prong adapter in a 2-hole ungrounded outlet.
• Do not use an extension cord.
• Do not plug the iR-M1 into a circuit with heating or refrigeration equipment
(including water coolers).
• Do not plug the iR-M1 into a switchable wall outlet. This can result in the iR-M1 be-
ing turned off accidentally.
COPYRIGHT © 2001 CANON INC.
CHAPTER 2 PREPARING FOR INSTALLATION
2000 2000 2000 2000 NM-PDL REV.0 JULY 2001
2-3