Canon FY8-13HR-000 Service Manual page 75

b. To Replace the HDD
1. Attach the HDD cable to the HDD and drape it over the top of the HDD.
Even though they are keyed, the connectors on the HDD cable are identical. Make sure
to connect the cable such that the red wire (pin 1) is nearest the middle of the HDD
when the cable is draped over the top of the HDD.
2. Position the HDD on the HDD carrier and secure with four screws.
The bottom of the HDD connects to the side of the HDD carrier without the guide rails.
HDD connectors are oriented away from the release tab on the HDD carrier.
3. Slide the HDD carrier along the guide rails on the center frame.
To make it easier to connect the cable, slide the HDD carrier in only part way.
4. Attach the power supply cable to the HDD.
5. Continue sliding the HDD carrier onto the center frame until the release tab clicks into
place.
6. Attach the HDD cable to motherboard connector J28. Align the connectors and push the
HDD cable connector straight in to avoid bending pins on the motherboard.
Straighten any bent pins with a pair of needlenose pliers.
7. Secure the top EMI shield to the main EMI shield with three screws.
Keep any loose metal shielding pressed in place.
8. If you removed the front panel, reattach it as described on page 4-7.
9. Reassemble the iR-M1 and verify its functionality as described on page 4-11.
Be sure to fold in the HDD cable so that it is not damaged when you re-
place the chassis cover.
Memo
10. If you replaced the HDD with a new drive, install system software (see "iR-M1 system
software" on page 4-36).
COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 NM-PDL REV.0 JULY 2001
CHAPTER 4 DISASSEMBLY/ASSEMBLY
4-33