Table of Contents
Advertisement
8. At the "Include Option Board Tests" screen, select Yes if you would like to run the
group of tests that run on the copier interface board, or select No to continue with the
diagnostic set you previously selected.
9. If you select Yes, the Option Board Tests menu appears. Make sure that the desired tests
are selected with an X and then select Continue.
10. At the "Run Tests Until" screen, select "All Tests Done" to run all the tests even if there
is a failure of one or more tests, or select "First Test Fails" to run the tests until one fails,
without running anymore diagnostics. Once you make your selection, tests begin imme-
diately.
Run Tests Until...
All Tests Done
First Test Fails
11. If no Diagnostics fail, the iR-M1 boots up normally. If a test fails, the name of the test
appears on the Display Window.
12. If a test fails, replace the motherboard.
Diagnostics
Continue Boot
Installation
Clear Server
Choose Function
Continue...
[X]HOST Bridge
[X]PCI Bridge
[X]ISA Bridge
[X]IDE Cntrl
[X]USB Cntrl
[X]ACPI Bridge
[X]ENET Ethernet
[X]IX Chip
[X]PAR Parallel
[X]SER1 Serial 1
[X]SER2 Serial 2
COPYRIGHT © 2001 CANON INC.
Continue...
[X]DEC PCI Bridge
[X]VID Video Chip
[X]SCSI Chip
F05-302-04
Select to run all tests and then view any failures after complete
Select to run until one test fails, stopping all other tests
F05-302-05
Startup
Custom
Diagnostics
Include Option
Board Tests
Option Board Tests
F05-302-06 iR-M1 diagnostic overview
2000 2000 2000 2000
NM-PDL REV.0 JULY 2001
CHAPTER 5 TROUBLESHOOTING
Tests begin running (see page 5-11).
Continue...
Yes
[X]DEC PCI Bridge
[X]VID Video Chip
No
[X]SCSI Chip
Run Tests Until...
All Tests Done
First Test Fails
Tests begin running.
5-13
Advertisement
Table of Contents
Troubleshooting
