Shutting Down And Restarting The Ir-M1; To Shout Down The Ir-M1; To Restart The Ir-M1; To Reboot The System - Canon FY8-13HR-000 Service Manual

3 Shutting Down and Restarting the iR-M1

The iR-M1 will usually be left on all the time at the customer site. Remember that when
the iR-M1 is powered off, network access to the copier is interrupted. Always obtain permis-
sion from the network administrator to take the iR-M1 off the network.
There are three ways to shut down the iR-M1:
• Restart Server—Resets the iR-M1 without shutting it down completely (soft reset).
• Shut Down System—Shuts down the iR-M1 and indicates when it is safe to power off
the iR-M1 using the power switch on the back panel.
• Reboot System—Shuts down and then reboots the iR-M1 (hard reset).
You should shut down the system when you need to service the iR-M1 or the copier, and
before you remove or attach any cables to the iR-M1.

3.1 To Shout Down the iR-M1

1. Make sure that the iR-M1 Info screen reads Idle.
When Printing or Ripping appears on the iR-M1 Control Panel, the iR-M1 is currently
processing a print job. Wait until the job is complete and Idle appears in the Info screen.
2. Press the menu button once, then select Reboot Server. At the next screen, select Shut
Down System.
Shutdown in progress appears on the Control Panel. About 30 seconds later, the message
It is now safe to power off the system appears.
3. Power off the iR-M1 using the power switch on the back panel.

3.2 To Restart the iR-M1

1. If the iR-M1 is already on, make sure that the iR-M1 Info screen reads Idle.
When Printing or Ripping appears on the iR-M1 Control Panel, the iR-M1 is currently
processing a print job. Wait until the job is complete and Idle appears in the Info screen.
2. Press the menu button once, then select Reboot Server from the Functions menu. At the
next screen, select Restart Server.

3.3 To Reboot the System

1. If the iR-M1 is already on, make sure that the iR-M1 Info screen reads Idle.
When Printing or Ripping appears on the iR-M1 Control Panel, the iR-M1 is currently
processing a print job. Wait until the job is complete and Idle appears in the Info screen.
2. Press the menu button once, then select Reboot Server. At the next screen, select Reboot
System.
COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 NM-PDL REV.0 JULY 2001
CHAPTER 3 INSTALLATION
3-15