To Run Ir-M1 Custom Diagnostics - Canon FY8-13HR-000 Service Manual

CHAPTER 5 TROUBLESHOOTING

3.2 To Run iR-M1 Custom Diagnostics

1. If the iR-M1 is on, power it off as described on page 4-3.
2. Press and hold the up button on the Control Panel.
3. Power on the iR-M1.
4. Release the up button as soon as you see the Choose Function screen display.
Diagnostics
Continue Boot
Installation
Clear Server
Choose Function
5. Select Diagnostics from the Choose Function screen.
6. When prompted choose Custom from the Diagnostics menu.
Startup
Custom
Diagnostics
7. At the next screen a list of tests appears. All diagnostic tests are marked with an X; if
there is a diagnostic test that you do not want to run, press the button next to the name to
remove the X. When the desired tests are selected, press the button next to Continue.
5-12
Select to proceed to the Diagnostics menu
Select to resume iR-M1 startup
Select to begin system software installation procedure
Select to clear all saved information on the iR-M1 HDD
F05-302-01
Select to go to the Custom diagnostics menu
F05-302-02
Continue...
[X]HOST Bridge
[X]PCI Bridge
[X]ISA Bridge
[X]IDE Cntrl
[X]USB Cntrl
[X]ACPI Bridge
[X]ENET Ethernet
[X]IX Chip
[X]PAR Parallel
[X]SER1 Serial 1
[X]SER2 Serial 2
F05-302-03
COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 NM-PDL REV.0 JULY 2001