Canon FY8-13HR-000 Service Manual page 54

CHAPTER 4 DISASSEMBLY/ASSEMBLY
6. Place the iR-M1 in its standard operating position. Secure the chassis cover to the center
frame with the four screws previously removed (see F04-201-01 on page 4-4).
Do not leave the chassis cover off after servicing. An air flow channel is
created by the chassis cover and the fans. Leaving the chassis cover off
could reduce the operational life expectancy of internal iR-M1 components.
Memo
7. Verify iR-M1 operation as outlined below.
Note that the iR-M1 must be powered off before any cables are attached to the back
panel.
4-12
Power on the iR-M1 alone to check
startup (see page 3-1).
Connect the iR-M1 to the copier
(see page 3-3).
Print the iR-M1 Test Pages
(see page 3-4).
Connect the iR-M1 to the network and
/or to a PC (see page 3-5, page 3-7,
and the Configuration Guide).
Check the Setup options
(see the Configuration Guide).
F04-303-02 iR-M1 connection verification steps
COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 NM-PDL REV.0 JULY 2001