Copier Interface Board; To Remove The Copier Interface Board; To Replace The Copier Interface Board - Canon FY8-13HR-000 Service Manual

Network multi-pdl printer unit-m1/ image pass-m1

Table of Contents

CHAPTER 4 DISASSEMBLY/ASSEMBLY

4.3 Copier Interface Board

The copier interface board in the iR-M1 provides the interface between the iR-M1 and the

copier. The copier interface board attaches to motherboard connector J17. The copier inter-

face port on one edge of the board connects to the copier interface cable that plugs into the

copier.

Copier interface port

1. Power off and open the iR-M1 as described on page 4-3 and page 4-4. For stability dur-

ing service, remove the front panel as described on page 4-6.

2. Remove the screw on the side of the port bracket that secures the copier interface board

to the port bracket.

3. Remove the copier interface board from motherboard connector J17.

Grasp the board at the sides. Gently pull the board straight up, until it releases from the

connector.

4. Place the copier interface board in an antistatic bag.

1. Insert the copier interface board into motherboard connector J17. Make sure that the

copier interface port is in its slot.

2. Replace the screw you removed earlier to secure the copier interface board to the port

bracket.

3. Replace the front panel as described on page 4-7.

4. Reassemble the iR-M1 and verify its functionality as described on page 4-11.

4-16

F04-403-01 Copier interface board layout

To connector J17 on

the motherboard

2000 2000 2000 2000

NM-PDL REV.0 JULY 2001

Table of Contents

Ir-m1 Image pass-m1 Unir-m1