To Replace The Uib - Canon FY8-13HR-000 Service Manual

4.2.2 To Replace the UIB

1. Place the UIB inside the front panel.
Make sure the buttons in the front panel stay in place. Also, make sure no dust or marks
are on the display window glass of the UIB. See "Precautions" on page v.
2. Secure the UIB to the inside front panel with the four screws previously removed from
the UIB.
3. Attach the UIB cable to the keyed connector on the UIB, making sure to lock it in place
using the levers (see F04-402-03).
Lever
4. Position the UIB enclosure above the front panel and thread the UIB cable through the
UIB cable slot.
5. Install the UIB enclosure.
When properly aligned, the eight notches on the UIB enclosure fit over the eight guides
molded along the inside edge of the front panel.
Tuck in all the loose metal shielding along the edges of the UIB enclosure. Make sure
the top and bottom lip of the UIB enclosure rest on the molding.
6. Attach the UIB cable to motherboard connector J30.
7. Reassemble the iR-M1 and verify its functionality as described on page 4-11.
COPYRIGHT © 2001 CANON INC.
F04-402-03 UIB cable connector
2000 2000 2000 2000 NM-PDL REV.0 JULY 2001
CHAPTER 4 DISASSEMBLY/ASSEMBLY
Lever
4-15