Wavion WBS-2400 User Manual page 78

SSID and VLAN configuration
2. In the Rename SSID field, enter an SSID Name to be used.
3. Check the SSID Enabled checkbox. This enables the SSID.
4. Check whether this SSID is a Backhaul SSID ( See Backhaul CPE)
5. Configure all security parameters: Authentication, and Encryption as required (See
Configurations).
6. Configure the QoS Priorization (See
7. Within the Related VLAN edit the VLAN Name
8. Select a VLAN ID. This ID should be unique and must be supported by the backbone
equipment that is connected to the WBS through the Ethernet port.
9. Ensure the Ethernet Tagging Enable is checked.
10. Make sure the VLAN and SSID are enabled by marking the VLAN Enabled and SSID enabled
checkbox respectively.
11. Click Apply.
Rev 4.0
QoS Priorization Settings)
Security
User Manual 78