Wavion WBS-2400 User Manual page 17

This page contains basic static information on the system, such as contact details, and IP
addresses. Several changes are recommended on this page.
Setting System Contact Details
In the System Identity area, in the System Contact field, enter the contact email address of the
net owner.
Setting the IP Address Configuration
Change the IP address to allow the full configuration. The Current IP Address Configuration
area lists a default IP address; it is possible to perform initial testing with this address, but it is
highly recommended to change the IP address.
To change the IP address
In the IP Address Configuration section,
1. For a DHCP obtained address, select DHCP. Following a reboot, the WBS-2400 will
automatically obtain and IP address, Subnet mask, and Default Gateway from the DHCP
server.
2 To allow entry of a new IP address, select Static from the Configured Boot Protocol
dropdown list.
3 In the Configured IP Address field, enter the required IP address.
4 In the Configured Subnet Mask, enter a valid network mask.
Note: The system must be rebooted for these changes to take effect.
Setting the Management VLAN configuration
The purpose of the management VLAN is to segment the Management and the Clients data
traffic. It also provides an option for customers to keep an Open SSID for public traffic and
simultaneously manage the WBS-2400 traffic over a separate VLAN (that may be linked to a
secured SSID). The management VLAN can be selected out of the enabled VLAN list.
Note:
WBS-2400 system.
The configuration of the Management VLAN takes effect immediately.
This means that setting the Management VLAN has to be done in 2 steps:
17 Wavion
Only one VLAN can be defined as the Management VLAN in the
Managing the System Configuration