Wavion WBS-2400 User Manual page 20

Managing the System Configuration
1. Default Except IP – In this case, the unit will lose its current setting without changing the IP
address. This option is convenient when choosing to return to default from a remote
location.
2. Default – In this case, the unit will lose its current setting and gets system defaults of IP:
192.168.1.1 and mask: 255.255.255.0
To return to the system default software version
1. Click Default or Default Except IP.
2. Click OK
A warning popup displays.
Figure 2.3 Default Popup
The system returns to the default software version and default IP and mask settings.
Note: Is possible to return to factory defaults using the reset pushbutton.
Press the button firmly until the "STATUS" LED blinks fast with red light
(around 40 seconds).
The reset button differs in location according to the WBS HW model:
The configuration, SW version, and SDMA license status will revert to
default.
Rev 4.0
If your WBS has a connection box, the reset pushbutton is
◊
located in the box.
◊ If your WBS has only ETH and TEST ports, the reset button
is located in the PoE injector next to the PoE output port.
User Manual 20