Wavion WBS-2400 User Manual page 18

Managing the System Configuration
1. Applying the VLAN parameters (external VLAN ID and tagging mode) using the
existing management traffic, and selecting the desired VLAN to be the Management
VLAN on the Administration page. After this stage the current wire-line connection
to the system GUI will drop.
2. Saving the parameters – using the new Management VLAN, i.e. over the tagged
VLAN.
To enable VLAN management
1. Apply the VLAN parameters (external VLAN ID and tagging mode) using the existing
management traffic or create a new VLAN ID.
2. Select the desired VLAN ID for the Management VLAN traffic.
3. Click Apply and Save
Note:
immediately. Therefore setting the Management VLAN is done over the
"old" VLAN (default is VLAN-1 untagged), while saving is done over the
"new" VLAN.
The 3
different machine/ the new VLAN.
Setting the System Management Configuration
You can decide to allow system management from the Wireless Interface, or to allow
management only from the Ethernet Interface, for security purposes.
To enable or disable system management from the Wireless
Interface
In the System Management Configuration area, in the Management from Wireless field, from
the dropdown list, select enabled to allow system management from the wireless interface, or
Disabled to restrict system management to the Ethernet Interface.
To enable or disable Startup Wizard
From the dropdown list, select "Disabled" to stop performing the Startup Wizard after each
login.
Rev 4.0
The configuration of the Management VLAN takes effect
rd
step in "To enable VLAN management has to be done over a
User Manual 18