Wavion WBS-2400 User Manual page 28

Managing the System Configuration
Figure 2.11 Debug Interface Page
Table- 2.4 Debug Interface page
Field
Common Debug
Interface File Upload
Module Control
ID/Args
Tech. support
button
File List
ARP PING
Source IP address
Destination IP address
Rev 4.0
Description
In rare cases you will be asked by Wavion technical person to upload
a file into the system to help critical issue debugging.
These codes will be given by Wavion Technical support person to
load to the system in order to get help with critical debugging.
This button creates a Tech Support Report file with all the unit's
configuration and other information needed by Wavion Tech Support
Department in order to debug a problem.
This list contains debugging files that helps Wavion technical support
to define HW or SW problems in field.
Please send this file to Wavion technical support for analyzing your
system conditions.
This tool test the connectivity of the WBS by sending a L2 PING
towards a device in a specific broadcast domain
IP address to be set as SENDER in the ARP message. This IP should
be an available address and must lay on the same subnet as the
destination IP address
IP address to be set as TARGET in the ARP message. This IP address
must lay on the same subnet as the source IP address
User Manual 28