Table of Contents
Advertisement
SERIAL SETUP
Configure connected serial devices.
SERIAL TYPE – Set External Controller or None.
MODEL – If External Controller is enabled, select the model
from the list.
PORT – Define port setting.
CLIENT SETUP
Configure general remote access
REMOTE PORT – Use this port number when configuring
remote access software. The default port is 2000 but can be
reconfigured.
WEB PORT – Used for remote connections using a web
browser. This port should be left open on the router. Default
web port is 80.
REMOTE CONFIGURATION – Enable to allow a remote
user to change configurations.
MAX TRANSFER SPEED – Set network bandwidth. If the
network is low speed, set this value as the network (aka.
Bandwidth Throttling).
27717AN
NETWORK SETUP - CLIENT
REMOTE PORT
2000
WEB PORT
80
REMOTE CONFIG
ENABLE
MAX TRANSFER SPEED
100 Mbps
NETWORK
SERIAL
SAVE
CLIENT
E-MAIL
CANCEL
37
Advertisement
Table of Contents
