2.2.1.2
MP-124 Rear Panel
The device's rear panel (shown in the figure below) provides the ports for cabling the device
to the various interfaces.
The table below describes the MP-124 rear panel components.
Table 2-5: MP-124 Rear-Panel Component Descriptions
Item #
Label
1
100-250 V~
50 - 60 Hz 2A
2
- or -
48V 1.3A
ANALOG FXS LINES
3
1–24
4
RS-232
5
ETHERNET
The Ethernet LEDs are located within the RJ-45 socket. The table below describes these
LEDs.
Table 2-6: MP-124 Rear-Panel Ethernet LEDs Description
Label
Type
ETHERNET
Ethernet
Status
Installation Manual
Figure 2-14: MP-124 Rear Panel - AC Power Model
Figure 2-15: MP-124 Rear Panel - DC Power Model
Protective earthing screw (mandatory for all installations).
Accepts a 6-32 UNC screw.
MP-124 can be ordered with one of the following power
configurations:
AC power: provides an AC power supply socket
DC power: provides a DC inlet for a DC terminal block
50-pin Telco connector for 1-24 analog lines.
9-pin RS-232 port.
10/100Base-TX Ethernet RJ-45 port.
Color
Green
Red
Component Description
State
On
Valid 10/100Base-TX Ethernet
connection.
On
Malfunction.
22
MediaPack Series
Function
Document #: LTRT-59813