Cabling The Mp-124; Figure 2-11: Mp-124 (Fxs) Rear Panel Connectors; Table 2-5: Mp-124 Rear Panel Component Descriptions; Table 2-6: Mp-124 Cables And Cabling Procedure - AudioCodes MP-124 Fast Track Manual

Analog Fast Track Guide
2.2.4

Cabling the MP-124

Figure 2-11
components, refer to
Cable your MP-124 according to each section of
Item #
1
2
100-250 V~ 50 - 60 Hz 2A
3
ANALOG FXS LINES 1 –24
5
6
Cable
Protective
earthing strap
RJ-45 Ethernet
cable
50-pin Telco
cable (MP-124
devices only).
An Octopus
cable is not
included with
the MP-124
package.
Version 5.0
http://ArtTel.ru
illustrates the rear panel of the MP-124. For descriptions of the MP-124 rear panel
Table 2-5.

Figure 2-11: MP-124 (FXS) Rear Panel Connectors

Table 2-5: MP-124 Rear Panel Component Descriptions

Label
Protective earthing screw (mandatory for all installations).
AC power supply socket.
50-pin Telco for 1 to 24 analog lines.
9-pin RS-232 status port.
RS-232
10/100 Base-TX Ethernet connection.
ETHERNET

Table 2-6: MP-124 Cables and Cabling Procedure

Connect an earthed strap to the chassis protective earthing screw and fasten it securely
according to the safety standards.
Connect the MP-124 Ethernet connection directly to the network using a crossover
RJ-45 Ethernet cable. For connector pinouts, refer to
Note that when assigning an IP address to the MP-124 using HTTP (under Step
Section 3.1.1), you may be required to disconnect this cable and re-cable it differently.
Refer to the MP-124 Safety Notice below.
1. Wire the 50-pin Telco connectors according to the pinouts in
and Figure 2-14 on page 17.
2. Attach each pair of wires from a 25-pair Octopus cable to its corresponding socket on
the MDF Adaptor Block's rear.
3. Connect the wire-pairs at the other end of the cable to a male 50-pin Telco
connector.
4. Insert and fasten this connector to the female 50-pin Telco connector on the
MP-124 rear panel (labeled Analog Lines 1-24).
5. Connect the telephone lines from the Adaptor Block to a fax machine, modem, or
telephones by inserting each RJ-11 connector on the 2-wire line cords of the POTS
phones into the RJ-11 sockets on the front of an MDF Adaptor Block as shown in
Figure 2-14 on page 17.
Table 2-6.
Component Description
Cabling Procedure
Figure 2-12
15
2. Installing the MediaPack
below.
1 in
Figure 2-13 on page 16,
October 2006