3Com 5000/6000 Quick Reference Manual page 9

3Com Router 5000/6000 Family
Command Reference
balance
Use the
balance
band-based-sharing
Use the
band-based-sharing
baudrate
Use the
baudrate
bert
Use the
bert
bert (CT1/PRI Interface)
Use the
bert
bert (CT3 Interface)
Use the
bert
bgp
Use the
bgp
This command is used to enable and disable BGP as well as to specify the local AS number of BGP.
bims boot request
Use the
bims boot request
management system (BIMS) center at startup.
bims device-id string
Use the
bims device-id
bims enable
Use the
bims enable
bims interval
Use the
bims interval
is set to 0, the BIMS device does not access the BIMS center regularly.
bims ip address
Use the
bims ip address
bims request
Use the
bims request
bims-server
Use the
bims-server
DHCP server.
bims sharekey
Use the
bims sharekey
center.
bims source ip-address
Use the
bims source ip-address
BIMS device. It can be the IP address of a port on the router.
bims specify-time
Use the
bims specify-time
specified time and if desired, configure the device to access the BIMS center at regular intervals from then
on during a specified period.
command to configure the number of routes participating in BGP load balancing.
command to enable bandwidth-based unbalanced load sharing.
command to set the baud rate of a serial interface.
command to set test error bit for line Bit.
command to start a BERT test on the CT1/PRI interface.
command to start a BERT test on the CT3 interface.
command to enable BGP and enter the BGP view.
command to enable the BIMS device to access the branch intelligent
command to configure the unique identifier of the BIMS device at the BIMS center.
command to enable BIMS.
command to configure the interval for accessing the BIMS center. When the interval
command to configure the IP address and port number of the BIMS center.
command to have the BIMS device access the BIMS center.
command to enable and configure BIMS option for a global address pool on the
command to configure the shared key between the BIMS device and the BIMS
command to specify a source IP address for the packets sent by the
command to configure the BIMS device to access the BIMS center at the
BGP view
System view
Serial Interface view
CE3 interface view
CT1/PRI Interface view
CT3 Interface view
System view
System view
System view
System view
System view
System view
System view
Global DHCP Address Pool view
System view
System view
System view
9