3Com Router 5000/6000 Family
Command Reference
stopbits
Use the
stopbits
stub
Use the
stub
subscriber-line
Use the
subscriber-line
subscriber-line
Use the
subscriber-line
view.
substitute
Use the
substitute
or voice entity.
substitute incoming-call
Use the
substitute incoming-call
from the network side to the number-substitute list.
substitute outgoing-call
Use the
substitute outgoing-call
the network side to the number-substitute list.
summary
Use the
summary
summary
Use the
summary
summary
Use the
summary
super
Use the
super
the user can access.
super authentication mode
Use the
super authentication-mode
which can be configured to the following four modes:
super password
Use the
super password
one.
sync-clock enable
Use the
sync-clock enable
board.
sync-clock interval
Use the
sync-clock interval
OSM board.
synchronize arp
Use the
synchronize arp
command to set the stop bits on the user interface.
command to configure the type of an OSPF area as the STUB area.
command to enter the voice subscriber-line view.
command to enter FXS, FXO, analog E&M, or digital E1/T1 voice subscriber-line
command to bind the calling/called number-substitute list to the voice subscriber-line
command to bind the calling/called numbers of the incoming calls
command to bind the calling/called numbers of the outgoing calls from
command to configure automatic aggregation of sub-network routes.
command to configure IS-IS route summary.
command to enable RIP-2 automatic route summarization.
command to switch the current user level to a specified user level, or the command level that
command to configure authentication mode for the super command,
command to set the password needed to switch from a lower user level to a higher
command to enable clock synchronization between the router and the OSM
command to set clock synchronization interval between the router and the
command to enable authorized ARP for global DHCP address pools.
User Interface view
OSPF Area view
Any Voice view except for Voice Entity view
Voice Entity View
Voice Subscriber-Line view
Voice Dial Program view
Voice Dial Program view
BGP Multicast view
BGP Unicast view
VPN Instance view
User Interface view
GigabitEthernet Interface view
GigabitEthernet Interface view
Global DHCP Address Pool view
145
Voice view
IS-IS view
RIP view
User view
System view
Need help?
Do you have a question about the 5000/6000 and is the answer not in the manual?