3Com 5000/6000 Quick Reference Manual page 71

3Com Router 5000/6000 Family
Command Reference
fr congestion-threshold
Use the
fr congestion-threshold
interface.
fr de del
Use the
fr de del
fr del inbound-interface
Use the
fr del inbound-interface
received from the specified interface, if it is forwarded from the router as a frame relay packet, its DE flag
bit is set to 1 before being forwarded.
fr del protocol ip
Use the
fr del protocol ip
relay packet encapsulated with an IP packet matching the specified rule will be flagged as 1.
fr dlci
Use the
fr dlci
fr dlci-switch
Use the
fr dlci-switch
fr inarp
Use the
fr inarp
fr interface-type
Use the
fr interface-type
fr ip-dscp
Use the
fr ip-dscp
the DSCP identifier in the IP packet is used to identify the priority levels of packets.
fr ip-precedence
Use the
fr ip-precedence
when the Precedence identifier in the IP packet is used to identify the priority levels of packets.
fr iphc
Use the
fr iphc
compression.
fr lmi n391dte
Use the
fr lmi n391dte
fr lmi n392dce
Use the
fr lmi n392dce
fr lmi n392dte
Use the
fr lmi n392dte
fr lmi n393dce
Use the
fr lmi n393dce
fr lmi n393dte
Use the
fr lmi n393dte
command to enable congestion management function of a frame relay
command to apply a DE rule list to the specified frame relay virtual circuit.
command to configure an interface-based DE rule list. For the packet
command to configure an IP-based DE rule list. The DE flag bit of the frame
command to configure the virtual circuit for Frame Relay interface.
command to configure a static route for frame relay PVC switching.
command to enable the inverse address resolution of Frame Relay.
command to set the Frame Relay interface type.
command to configure the PVC to carry packets of the specified priority levels when
command to configure the PVC to carry packets of the specified priority levels
command to enable IP header compression function, including RTP/TCP header
command to configure N391 parameter at the DTE side.
command to set N392 parameter at the DCE side.
command to set N392 parameter at the DTE side.
command to set the N393 parameter at the DCE side.
command to set N393 parameter at the DTE side.
Frame Relay Interface view
MFR Interface view
Frame Relay Interface (or Subinterface) view
MFR Interface view
PVC Group view
Frame Relay Interface view
MFR Interface view
FR Pvc-Group view
FR Pvc-Group view
Frame Relay Interface view
MFR Interface view
71
System view
System view
Interface view
Interface view
Interface view
Interface view
Interface view
Interface view
Interface view
Interface view