3Com 5000/6000 Quick Reference Manual page 143

3Com Router 5000/6000 Family
Command Reference
ssh user service-type
Use the
ssh user service-type
ssh2
Use the
ssh2
exchange algorithm, encryption algorithm and HMAC algorithm between the client and the server.
ssh2 source-interface
Use the
ssh2 source-interface
interface, for the SSH client. After that, the IP address of the specified interface is used as the source IP
address in each packet sent by the SSH client.
ssh2 source-ip
Use the
ssh2 source-ip
This IP address must be a local IP address.
standby bandwidth
Use the
standby bandwidth
backup load sharing.
standby detect-group
Use the
standby detect-group
standby interface
Use the
standby interface
standby routing-group
Use the
standby routing-group
interface.
standby routing-rule
Use the
standby routing-rule
monitored network segment to it.
standby threshold
Use the
standby threshold
standby timer delay
Use the
standby timer delay
frequent switchover caused by instability of interface state.
standby timer flow-check
Use the
standby timer flow-check
main interface.
standby timer routing-disable
Use the
standby timer routing-disable
disconnected after the primary link goes up to avoid route oscillation.
start l2tp
Use the
start l2tp
L2TP LAC.
start l2tp tunnel
Use the
start l2tp tunnel
start script
Use the
start-script
command to specify service type for a user.
command to initiate a connection to the specified SSH server, and specify the preferred key
command to specify a source interface, which must be an existing local
command to specify a source IP address for the packets sent by the SSH client.
command to configure the actual bandwidth that the main interface uses in
command to implement interface backup using the auto detect function.
command to specify a physical interface to back up the interface.
command to apply a dynamic routing standby group on the secondary
command to create a dynamic routing standby group and assign a
command to configure backup load sharing on an interface or logical channel.
command to set failover and fallback delays on the interface, avoiding
command to configure the interval for checking the traffic size on the
command to specify a delay for the secondary link to be
command to specify conditions triggering the local end to place calls when it works as
command to enable the L2TP LAC to start L2TP tunnel connection.
command to configure executing the specified Modem script on an interface.
143
System View
System view
System view
System view
Interface view
Interface view
Interface view
Dial Interface view
System view
Interface view
Interface view
Interface view
Dial Interface view
L2TP Group view
L2TP Group view
User view