3Com 5000/6000 Quick Reference Manual page 100

100
motorola base-svc
Use the
motorola base-svc
motorola encapsulation
Use the
motorola encapsulation
motorola max-voice
Use the
motorola max-voice
DLCI concurrently.
motorola remote-id
Use the
motorola remote-id
move
Use the
move
mpls
Use the
mpls
Use the
mpls
mpls l2vc
Use the
mpls l2vc
mpls l2vpn
Use the
mpls l2vpn
mpls l2vpn encapsulation
Use the
mpls l2vpn encapsulation
type, and enter MPLS L2VPN view.
mpls-exp
Use the
mpls-exp
EXP identifier in the MPLS packet is used to identify the priority levels of packets.
mpls label advertise
Use the
mpls label advertise
the penultimate hop.
mpls ldp
Use the
mpls ldp
mpls ldp enable
Use the
mpls ldp enable
mpls ldp hops-count
Use the
mpls ldp hops-count
mpls ldp loop-detect
Use the
mpls ldp loop-detect
mpls ldp password
Use the
mpls ldp password
command to configure the start SVC for voice routing on a DLCI.
command to specify an encapsulation for Motorola LCON on the DLCI.
command to configure the maximum number of voice channels created on a
command to configure a remote connection ID.
command to move a file.
command in system view to enable MPLS globally and enter MPLS view.
command in interface view to enable MPLS on the interface.
command to create an LDP connection.
command to enable L2VPN.
command to create Kompella MPLS L2VPN, specify encapsulation
command to configure the PVC to carry packets of the specified priority levels when the
command to specify at the egress the type of the label to be distributed to
command to enable LDP.
command to enable LDP on the interface.
command to set the maximum hops of loop detection.
command to enable loop detection.
command to configure LDP authentication mode.
3Com Router 5000/6000 Family
Command Reference
DLCI view
DLCI view
DLCI view
DLCI view
User view
Interface view
Routing Protocol view
System view
Virtual Interface view
Interface view
System view
System view
ATM Pvc-Group view
MPLS view
System view
Interface view
System view
System view
Interface view
Remote-Peer view