3Com 5000/6000 Quick Reference Manual page 14

14
cid enable
Use the
cid enable
cid select-mode
Use the
cid select-mode
up VoFR calls.
cid send
Use the
cid send
cid type
Use the
cid type
cir
Use the
cir
cir allow
Use the
cir allow
classifier behavior
Use the
classifier behavior
clear-forward-ack
Use the
clear-forward-ack
clear-back signal when the originating point (calling party) disconnects a call.
clns enable
Use the
clns enable
clns erpacket enable
Use the
clns erpacket enable
clns erpacket interval
Use the
clns erpacket interval
report packets.
clns es-peer
Use the
clns es-peer
clns net
Use the
clns net
clns rdpacket enable
Use the
clns rdpacket enable
clns rdpacket interval
Use the
clns rdpacket interval
clns route-static
Use the
clns route-static
clns timer rdpacket holding
Use the
clns timer rdpacket holding
carries.
clock
Use the
clock
command to enable CID on the FXO interface.
command to configure the route selection mode used by the calling party to set
command to enable the FXO or FXS module to send calling numbers to the IP side.
command to configure the format of transmitted information about the calling party.
command to set the CIR of frame relay virtual circuit.
command to set the CIR ALLOW of frame relay virtual circuit.
command to specify the behavior for the class in the policy.
command to enable or disable the terminating point to respond by sending a
command to enable CLNS.
command to enable generation of error report packets.
command to set the minimum interval to generate two successive error
command to configure a static neighboring ES.
command to assign an NET address to the IS.
command to enable the router to send RD packets.
command to set the minimum interval to generate RD packets.
command to configure a static OSI route.
command to set the holding time of the information a RD packet
command to set the clock mode of the ATM E1/T1 interface.
3Com Router 5000/6000 Family
Command Reference
Voice Subscriber-Line view
DLCI view
Voice Subscriber-Line view
Voice Subscriber-Line view
Frame Relay Class view
Frame Relay Class view
Policy view
R2 CAS view
System view
System view
System view
System view
System view
System view
System view
System view
System view
ATM E1/T1 Interface view