3Com Router 5000/6000 Family
Command Reference
nat outbound static
Use the
nat outbound static
configured using the
nat overlapaddress
Use the
nat overlapaddress
nat server
Use the
nat server
server with the address and port as host-addr and host-port respectively through the address port defined
by global-addr and global-port.
nat static
Use the
nat static
nat static inside
Use the
nat static inside
addresses based on this type of NAT entry, it translates the network address portion without touching the
host address portion.
nat traversal
Use the
nat traversal
national-bit
Use the
national-bit
naturemask-arp
Use the
naturemask-arp enable
subnets.
nbns-list
Use the
nbns-list
the clients.
nesting
Use the
nesting
netbios-type
Use the
netbios-type
address pool.
network
Use the
network
network
Use the
network
network
Use the
network
network
Use the
network
network
Use the
network
command to apply on the interface one-to-one address translation
command.
nat static
command to map an overlapping address pool to a temporary address pool.
command to define a mapping table for internal servers. Users can access the internal
command to configure a one-to-one private-to-public address binding.
command to create a static net-to-net NAT entry. When the router translates
command to configure the NAT traversal function of IKE/IPSec.
command to configure national bit on the CE3 interface.
command to support ARP within natural network segments rather than
command to configure NetBIOS server addresses in a global DHCP address pool for
command to configure a nesting rule.
command to configure the NetBIOS node type of the clients of a global DHCP
command to configure the network routes advertised by the local BGP system.
command to configure an IP address range used for dynamic allocation.
command to configure the network addresses to be sent by the local BGP.
command to configure the interface running OSPF.
command to enable Routing Information Protocol (RIP) on the interface.
Interface view
System view
Interface view
System view
System view
IKE-Peer view
CE3 Interface view
System view
DHCP Address Pool view
ACL view
DHCP Address Pool view
BGP view
DHCP Address Pool view
IPv4 Multicast Subaddress Family view
OSPF Area view
103
RIP view
Need help?
Do you have a question about the 5000/6000 and is the answer not in the manual?