3Com 5000/6000 Quick Reference Manual page 62

62
display x25 x2t switch-table
Use the
display x25 x2t switch-table
static routing table.
display x25 xot
Use the
display x25 xot
dl-bits
Use the
dl-bits
dlsw bridge-set
Use the
dlsw bridge-set
bridge-set
dlsw enable
Use the
dlsw enable
dlsw ethernet-backup enable
Use the
dlsw ethernet-backup enable
dlsw ethernet-backup map
Use the
dlsw ethernet-backup map
Ethernet redundancy, that is, to map the MAC address of a remote SNA device to a local virtual MAC
address.
dlsw ethernet-backup timer
Use the
dlsw ethernet-backup timer
waits before sending a positive or negative response to the slave DLSw router upon receipt of a circuit
establishing request.
dlsw ethernet-frame-filter
Use the
dlsw ethernet-frame-filter
directions of DLSW module towards bridge module so that it can transmit and receive only the Ethernet
frames with permitted source MAC addresses.
dlsw filter acl
Use the
dlsw filter acl
dlsw local
Use the
dlsw local
dlsw max-transmission
Use the
dlsw max-transmission
frame.
dlsw multicast
Use the
dlsw multicast
dlsw reachable
Use the
dlsw reachable
dlsw reachable-cache
Use the
dlsw reachable-cache
to the reachable-cache. You can specify this SNA device by specifying its MAC address and IP address of
the router to which it is connected.
dlsw remote
Use the
dlsw remote
command to view XOT link information.
command to configure the bit value of all the signals of R2 line signaling.
command to configure the bridge group to connect DLSw. Use the
command to delete the bridge.
command to enable DLSw performance.
command to enable DLSw Ethernet redundancy.
command to enable the Ethernet switch support feature for DLSw
command to configure the time for which the master DLSw router
command to apply an ACL in the transmitting and receiving
command to specify to filter packets from any peer.
command to create the DLSw local peer.
command to set the maximum number of the attempts to send an explorer
command to enable the multicast function of DLSw2.0.
command to configure locally reachable MAC and SAP addresses.
command to add the reachability information of the specified SNA device
command to create the DLSw remote peer.
command to display the dynamic switching routing table and
3Com Router 5000/6000 Family
Command Reference
Any view
Any view
R2 CAS view
undo dlsw
System view
System view
Ethernet Interface view
Ethernet Interface view
Ethernet Interface view
System view
System view
System view
System view
System view
System view
System view
System view