Configuring Ripng; Configuring Basic Ripng; Configuring Ripng Enhanced Function - Zte ZXR10 5900E Series User Manual

St- Command
ep
1
ipv6 router rip
ZXR10(config)#
2
ZXR10(config-if-vlanX)#
3
ZXR10(config-if-vlanX)#
4
ZXR10(config-if-vlanX)#
5
ZXR10(config-if-vlanX)#
ute [only]
6
ZXR10(config-if-vlanX)#
7
ZXR10(config-if-vlanX)#
8
ZXR10(config-if-vlanX)#
St- Command
ep
1
ZXR10(config-router)#
ut><garbage>
2
ZXR10(config-router)#
ric <1-16>}|{route-map <name>}]
3
ZXR10(config-router)#
128>
4 clear ipv6 rip route [X:X::X:X/<0-128>| all]
ZXR10#

Configuring RIPng

Configuring Basic RIPng

ipv6 rip active-interface
ipv6 rip enable
ipv6 rip neighbor X:X::X:X
ipv6 rip originate-default-ro
ipv6 rip passive-interface
ipv6 rip poison-reverse
ipv6 rip split-horizon
Configuring RIPng Enhanced
Function
To configure RIPng enhanced function, perform the following steps.
timers basic <update><timeo
redistribute <protocol>[{met
summary-prefix X:X::X:X/<0-
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 5 RIPng Configuration
Function
This enables a RIPng instance.
This configures one interface
sending packet only.
This enables RIPng on an
interface.
This configures the IP address
of RIPng neighbor.
This configures the default
route of RIPng.
This makes an interface
receiving messages only.
This configures poison-
reverse function.
This configures split-horizon
function.
Function
This configures RIPng timers.
This redistributes routes to
RIPng.
This configures route
aggregation.
This deletes RIPng routes.
29