Configuration Example - Zte ZXR10 5900E Series User Manual

Command
debug ipv6 icmp
ZXR10#
debug ipv6 packet
ZXR10#
debug ipv6 tcp driver
ZXR10#
debug ipv6 tcp packet
ZXR10#
debug ipv6 tcp transactions
ZXR10#
debug ipv6 tcp all
ZXR10#
debug ipv6 udp
ZXR10#

Configuration Example

This following shows the MTU configuration example.
ZXR10(config)#interface vlan1
ZXR10(config-if-vlan1)#ipv6 mtu 1400
The following example shows how to use the command of ping:
ZXR10#ping6 3ff::2
sending 64-bytes ICMP echos to 3ff::2,timeout is 1 seconds.
!!!!!
Success rate is 100 percent(5/5),round-trip min/avg/max= 0/1/9 ms
The following example shows how to use the command of show
ipv6 route:
ZXR10#show ipv6 route summary
IPv6 Routing Table Summary - 13 entries
3 connected, 1 static, 0 RIP, 0 BGP, 4 IS-IS, 5 OSPF
ZXR10#show ipv6 route isis
IPv6 Routing Table
Codes: C - connected, S - static, R - RIP, B - BGP,
I1 - ISIS L1, I2 - ISIS L2, IA - ISIS interarea, IS - ISIS static,
O - OSPF intra, OI - OSPF inter, E1 - OSPF ext 1, E2 - OSPF ext 2
Timers: Uptime
DHCPv6 relay configuration example is showed as the follows.
When DHCPv6 client terminal and server are not in the same
network, the router which connects the client terminal directly is
needed to be DHCPv6 relay.
As shown in Figure 4, enable DHCPv6 relay in R1, the single server
101:: 1/64 provides DHCPv6 server function.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 4 IPv6 Other Configurations
Function
This views IPv6 ICMP message
debug information.
This views IPv6 message
information which system
receives and sends.
This sets and closes IPv6 TCP
connection related information
debug switch.
This views system receiving
and sending IPv6 TCP message
information.
This sets debug switch of
IPv6 TCP status migration
information.
This opens all IPv6 TCP debug
information switch.
This opens IPv6 UDP debug
information switch.
25