Configuring Dhcpv6 Relay - Zte ZXR10 5900E Series User Manual

Command
ipv6 dhcp snooping trust Interface
ZXR10(config)#
<interface-id>
no ipv6 dhcp snooping trust Interface
ZXR10(config)#
<interface-id>
Command
ipv6 dhcp snooping vlan <14094>
ZXR10(config)#
no ipv6 dhcp snooping vlan <14094>
ZXR10(config)#
Command
ZXR10(config-if-vlanX)#
<1 2000>
Command
ZXR10(config-if-vlanX)#
ZXR10(config-if-vlanX)#
St- Command
ep
1 ipv6 dhcp [enable | disable]
ZXR10(config)#
2
ZXR10(config-if-vlanX)#
6. To enable Vlan DHCP SNOOPING, perform the following com-
mands.
7. To configure user quota at the layer 2 interface, perform the
following commands.
ipv6 dhcp snooping quota
8. To configure trust interface at the layer interface, perform the
following commands.
ipv6 dhcp snooping trust
no ipv6 dhcp snooping trust

Configuring DHCPv6 relay

DHCPv6 relay configuration includes the following commands:
ipv6 dhcp mode <relay>
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 4 IPv6 Other Configurations
Function
This configures the interface
whose interface number is <
interface-id > as trust interface.
This cancels the trust interface.
Function
This enables dhcpv6 snooping
of vlan.
This disables dhcpv6 snooping
of vlan.
Function
< 1-2000 > is quota number.
Function
This configures interface as trust
interface.
This cancels trust interface.
Function
This enable or disable
DHCPv6 relay function at
global configuration mode.
This configures dhcpv6 relay
function at the interface
mode.
23