ZXR10 5900E Series User Manual (IPv6 Volume)
St-
Command
ep
1
ZXR10(config)#
2
ZXR10(config-router)#
3
ZXR10(config-router)#
4
ZXR10(config)#
5
ZXR10(config-if-vlanX)#
St-
Command
ep
1
ZXR10(config-router)#
2
ZXR10(config-router)#
3
ZXR10(config-router)#
text}[ level-1 | level-2]
4
ZXR10(config-router)#
5
ZXR10(config-router)#
6
ZXR10(config-router)#
7
ZXR10(config-router)#
42
Confidential and Proprietary Information of ZTE CORPORATION
Configuring IS-ISv6
Enabling IS-ISv6
To enable IS-ISv6 process, perform the following steps.
router isis
area <area address>
system-id <id>
interface <interface-name>
ipv6 router isis
Configuring IS-ISv6 Global
Parameters
To configure global parameters, perform the following steps.
address-family ipv6
authentication <word>
authentication-type {md5 |
disable-snp-authentication
distance <1-255>
enable-snp-authentication
hello padding
Function
This initializes an IS-IS
routing entry.
This configures IS-ISv6 area
address.
This configures system ID of
an IS-IS routing entry.
This enters Layer 3 interface
configuration mode.
This runs IS-ISv6 on an
interface.
Function
This enters into ipv6 family
configuration mode.
This configures password.
This configures IS-ISv6
authentication type.
This disables SNP
authentication.
This configures administrative
distance of IS-ISv6.
This enables SNP
authentication.
This configures sending hello
message padding on the
interface till the message size
is equal to mtu of interface.