Configuring Pim-Sm; Booting Ipv6 Pim-Sm; Configuring Static Rp Address; Configuring Candidate-Bsr - Zte ZXR10 5900E Series User Manual

ZXR10 5900E Series User Manual (IPv6 Volume)
St- Command
ep
3
ZXR10(config-if-vlanX)#
se-time <seconds>
4
ZXR10(config-if-vlanX)#
ery-interval <seconds>
St- Command
ep
1
ZXR10(config)#
2
ZXR10(config-if-vlanX)#
Command
ipv6 router pimsm static-rp
ZXR10(config)#
<ipv6-addr>[group-list <access-name>]
Example
66 Confidential and Proprietary Information of ZTE CORPORATION
ipv6 mld query-max-respon
ipv6 mld last-member-qu

Configuring PIM-SM

Booting IPv6 PIM-SM

ipv6 router pimsm
ipv6 pim

Configuring Static RP Address

One static RP is allowed to be configured for one or multiple specific
groups. It is required to configure same static RPs for the group
on all PIM-SM multicast routers in the multicast area. Usually the
loopback interface address is used to reduce the network vibration
caused by the Up/Down of a physical interface. After the static RP
is configured, it is not necessary to configure the Candidate-RP for
the group.
To configure the static RP address, use the following command.
This example shows configuration of static RP 2001::1 for all
groups.
ZXR10(config)#ipv6 router pimsm static-rp 2001::1

Configuring Candidate-BSR

If the static RP mechanism is not used, each multicast area must
be configured with the Candidate-BSR on more than one multi-
Function
This configures maximum
response time contained in
the query message.
This configures MLD query
interval of specified group.
Function
This boots IPv6 PIM-SM.
This enables IPv6 PIM-SM on
an interface.
Function
This configures the static RP
address.