Configuring Bgp4+ Route Advertisement; Configuring Ebgp Multi-Hops Of Bgp4 - Zte ZXR10 5900E Series User Manual

Command
ZXR10(config-router)#
number>[route-map <name>]
ZXR10(config-router)#
<metric-value>][route-map <map-tag>]
Command
ZXR10(config-router)#
ebgp-multihop [ttl <value>]
Configuring BGP4+ Route
Advertisement
To configure BGP4+ route advertisement, use one of the following
commands.
network <ipv6 network
redistribute <protocol>[metric
Note:
Known routes on local device include direct-connected route, static
route and the route learnt through dynamic routing protocols.
Redistribute command is used to redistribute routes learnt by
IGP protocols (RIPng, OSPFv3 and IS-ISv6) into BGP4+. When
using this command, make sure that the routes learned by IGP
from BGP4+ are not redistributed into BGP4+. Use the filtering
command to prevent the loop from occurring if necessary.
Configuring EBGP Multi-Hops of
BGP4+
To configure EBGP multi-hops of BGP4+, use the following com-
mand.
neighbor <ipv6-address>
Note:
EBGP neighbors should be established on the straight-through in-
terfaces of two routers. To establish EBGP neighbors on the in-
terfaces that are not directly connected, use this command to
configure EBGP multi-hops. In addition, appropriate IGP or static
route configuration is required to enable the inter-working of these
neighbors.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 8 BGP4+ Configuration
Function
This advertises known routes on
local device
This redistributes routes learnt
by IGP protocols
Function
This configures EBGP multi-hops
of BGP4+
53