Configuring Mld; Configuring A Mld Group On An Interface; Configuring Mld Timers; Figure 14 Ipv6 Multicasting Route Configuration - Zte ZXR10 5900E Series User Manual

Command
ZXR10(config-if-vlanX)#
<group-address>
Example
St- Command
ep
1
ZXR10(config-if-vlanX)#
<seconds>
2
ZXR10(config-if-vlanX)#
<seconds>

Configuring MLD

Configuring a MLD Group on an
Interface
ipv6 mld static-group
It is allowed to bind the group addresses on interfaces statically,
that is, supposing the group member exists all the time.
This example shows how to configure static group ffe1::1 on in-
terface vlan1.
ZXR10(config)#interface vlan 1
ZXR10(config-if-vlan1)#ipv6 mld static-group ffe1::1

Configuring MLD Timers

After MLD is enabled on the interface of multicast router that is
connected to the sharing network segment, an optimal router is
selected as the querier. The querier is responsible for obtaining
member information by sending query messages.
After querier sends query message, it will wait for the host to send
report that contains member information within a period. The pe-
riod is the maximum response time contained in the query mes-
sage. After receiving the query message, the host member in the
network will subtract a random offset time from the maximum re-
sponse time and takes the outcome as its response time. If the
querier receives response reports from other host members within
the period, the reports will be discarded. Otherwise, the host re-
port will be sent. Therefore, to increase the maximum response
time is to add waiting opportunities of group members in network
segment and to reduce the rate of multi-host reports.
To configure MLD timers, perform the following steps.
ipv6 mld query-interval
ipv6 mld query-timeout
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 9 IPv6 Multicasting Route Configuration
Function
This configures a MLD group on
an interface.
Function
This configures MLD query
interval.
This configures MLD query
timeout.
65