Restore The Factory Default Settings - CyberData VoIP V3 Operation Manual

2.3.7 Restore the Factory Default Settings

The V3 Paging Server is delivered with factory set default values for the parameters in
the RTFM switch (see
default settings.
Note
To restore these parameters to the factory default settings:
1. Press and hold the RTFM switch until the status and paging lights come on.
2. Continue to press the switch until after the indicator lights go off, and then release it.
3. The V3 Paging Server settings are restored to the factory defaults.
CyberData Corporation
Figure 2-9) on the back of the unit to restore these parameters to the factory
RTFM Switch
When you perform this procedure, the factory default settings are restored. The default
parameters for access are shown in
Table 2-3. Factory Default Settings
Parameter
IP Addressing
a
IP Address
Web Access Username
Web Access Password
a
Subnet Mask
a
Default Gateway
a. Default if there is not a DHCP server present.
930427B
Figure 2-9. RTFM Switch
Table 2-3.
Factory Default Setting
DHCP
10.10.10.10
admin
admin
255.0.0.0
10.0.0.1
Setting Up the V3 Paging Server
Connecting the V3 Paging Server
Table 2-3. Use
Operations Guide
11