Connecting The V3 Paging Server; Connection Options - CyberData VoIP V3 Operation Manual

2.3 Connecting the V3 Paging Server

Before you connect the V3 Paging Server, be sure that you have received all of the parts described in
Section 2.1, "Parts

2.3.1 Connection Options

See Figure 2-3
Pin
1
2
3
4
5
6
7
a. The 600-Ohm audio output of the page port is also suited for interfaces with lower input
b. 1 Amp at 30 VDC for continuous loads
CyberData Corporation
List".
and Table 2-1 for the connection options that are available for the V3 Paging Server.
Line In
Table 2-1. Page Port Output Connections
Description
Fault Sense Input (Common). See
(Common/Sense)".
Fault Sense Input (Sense). See
(Common/Sense)".
Positive 600-Ohm Audio Output
Ohm Audio Output/Audio Ground
Negative 600-Ohm Audio Output.
Ohm Audio Output/Audio Ground
Audio Ground Reference. See
Output/Audio Ground Reference".
b
Relay Contact - Common
Open)".
Relay Contact - Normally Open
(Common/Normally Open)".
impedances.
Figure 2-3. Connection Options
Line Out Page Port Output
Pin 1 Pin2 Pin 3 Pin 4 Pin 5
Section 2.3.1.1, "Pin 1 and 2—Fault Sense Input
Section 2.3.1.1, "Pin 1 and 2—Fault Sense Input
a
. See Section 2.3.1.2, "Pin 3, 4, and 5—Positive/Negative 600-
Reference".
a
. See Section 2.3.1.2, "Pin 3, 4, and 5—Positive/Negative 600-
Reference".
Section 2.3.1.2, "Pin 3, 4, and 5—Positive/Negative 600-Ohm Audio
. See Section 2.3.1.3, "Pin 6 and 7—Relay Contact (Common/Normally
b
. See Section 2.3.1.3, "Pin 6 and 7—Relay Contact
930427B
Setting Up the V3 Paging Server
Connecting the V3 Paging Server
48VDC
Power
Pin 6 Pin 7
Operations Guide
6