CyberData VoIP V3 Operation Manual page 24

4. On the Home Page, review the setup details and navigation buttons described in
Web Page Item
Device Settings
Device Name
Change Username
Change Password
Re-enter Password
Current Settings
Serial Number
Mac Address
Firmware Version
IP Addressing
IP Address
Subnet Mask
Default Gateway
DNS Server 1
DNS Server 2
SIP Mode is
Event Reporting is
Nightring is
At this point you can:
• Review the V3 Paging Server's Current Settings. Use the RTFM switch to restore the factory
default settings. See
• Configure the network parameters. Click Network Setup and refer to
the Network Parameters"
• Configure the SIP parameters. Click SIP Setup and see
Parameters".
• Configure the PGROUPS parameters. Click PGROUPS Setup and see
the Paging Groups (PGROUPS) Parameters"
Note
CyberData Corporation
Table 2-5. Home Page Overview
2.3.7 "Restore the Factory Default
for instructions.
Click the Upgrade Firmware button any time you need to upload new versions of the
firmware. Refer to Section 2.5, "Upgrading the Firmware"
930427B
Description
Shows the device name (25 character limit).
Type in this field to change the username (25 character limit).
Type in this field to change the password (19 character limit).
Type the password again in this field to confirm the new password
(19 character limit).
Shows the device serial number.
Shows the device Mac address.
Shows the current firmware version.
Shows the current IP addressing setting (DHCP or Static).
Shows the current IP address.
Shows the current subnet mask address.
Shows the current default gateway address.
Shows the current DNS Server 1 address.
Shows the current DNS Server 2 address.
Shows the current status of the SIP Mode.
Shows the current status of the Event Reporting.
Shows the current status of the Nightringer.
Click the Save button to save your configuration settings.
Note: You need to reboot for changes to take effect.
Click on the Reboot button to reboot the system.
Settings".
for instructions.
Setting Up the V3 Paging Server
Configuring the V3 Paging Server
Section 2.4.5, "Configure
Section 2.4.6, "Configure the SiP
Section 2.4.9, "Configure
for instructions.
Operations Guide
16
Table 2-5.