Announcing The Ip Address; Restore The Factory Default Settings - CyberData 011146 Operation Manual

2.3.9 Announcing the IP Address

To announce the IP address for the Paging Server, briefly press and then quickly release the RTFM
switch. See

2.3.10 Restore the Factory Default Settings

The Paging Server is delivered with factory set default values for the parameters in
addition, the settings for various UI web pages (such as the
delivered with the factory default settings and can be restored to these default settings when you use
the RTFM switch. However, uploaded audio files are not restored to the factory default settings when
you use the RTFM switch.
Use the RTFM switch (see
factory default settings.
Note
To restore these parameters to the factory default settings:
1. Press and hold the RTFM switch until the status and paging lights come on.
2. Continue to press the RTFM switch until after you see the indicator lights go off and you hear the
3. Release the RTFM switch.
4. The Paging Server settings are restored to the factory defaults.
CyberData Corporation
Figure 2-8.
RTFM Switch
Figure
When you perform this procedure, the factory default settings are restored. The default
parameters for access are shown in
Parameter
IP Addressing
a
IP Address
Web Access Username
Web Access Password
a
Subnet Mask
Default Gateway
a. Default if there is not a DHCP server present.
"restoring defaults" announcement.
Figure 2-8. RTFM Switch
2-8) on the back of the unit to restore these parameters to the
Table 2-3.
Table 2-3. Factory Default Settings
Factory Default Setting
DHCP
10.10.10.10
admin
admin
255.0.0.0
a
10.0.0.1
931073B
Setting Up the Paging Server
Announcing the IP Address
Table
Device Page, SIP Page, etc.) are
Operations Guide
13
2-3. In