Restore The Factory Default Settings As Required - CyberData 010878 Operation Manual

2.3.4 Restore the Factory Default Settings as Required

The Paging Server is delivered with factory set default values for the following parameters. Use the
RTFM switch (see
default settings.
Note
Parameter
IP Addressing
IP Address
Subnet Mask
Default Gateway
Username
Password
To restore these parameters to the factory default settings:
1. Press and hold the RTFM switch for at least 120 seconds.
2. Release the switch. The Status and the Paging LEDs will go off. The Link and Activity LEDs
will come on for one second and go off to indicate that the reset process is starting.
3. During the reset process, the Link LED will come on and the Activity LED will blink. After five
seconds, the Status and Paging LEDs come back on.
4. The Paging Server settings are restored to the factory defaults.
VoIP Paging Server Operations Guide
Figure 2-5) on the back of the unit to restore these parameters to the factory
Figure 2-5. RTFM Switch
When you perform this procedure, the factory default settings are restored for all the
following parameters.
Factory Default Setting
static
192.168.3.10
255.255.255.0
192.168.3.1
admin
admin
930132F
Implementing the VoIP Paging Server
Setting up the Paging Server
CyberData Corporation
7