Log In To The Configuration Gui - CyberData VoIP V3 Operation Manual

Paging server
Hide thumbs Also See for VoIP V3:
Table of Contents

Advertisement

2.4.3 Log in to the Configuration GUI

1. Open your browser to the V3 Paging Server IP address.
Note
Note
Note
Note
2. When prompted, use the following default Username and Password to open the configuration
Home page:
Username: admin
Password: admin
Change the
To change the default Web access Username and Password:
Default Username
and Password
1. Enter the new Username from four to 25 alphanumeric characters in the Change Username
field. The Username is case-sensitive.
2. Enter the new Password from four to 20 alphanumeric characters in the Change Password field.
The Password is case-sensitive.
3. Enter the new password again in the Re-enter New Password field.
Click Save Settings.
CyberData Corporation
If the network does not have access to a DHCP server, the device will default to an IP
address of 10.10.10.10.
Make sure that the PC is on the same IP network as the V3 Paging Server.
You may also download CyberData's VoIP Discovery Utility program which allows you to
easily find and configure the default web address of the CyberData VoIP products.
CyberData's VoIP Discovery Utility program is available at the following website address:
http://www.cyberdata.net/support/voip/discovery_utility.html
The unit ships in DHCP mode. To get to the Home page, use the discovery utility to scan for
the device on the network and open your browser from there.
To work with the V3 Paging Server configuration after the initial configuration, log in using
the IP address you assign to the device.
provides instructions for entering the IP address.
930427B
Setting Up the V3 Paging Server
Configuring the V3 Paging Server
Section 2.4.5, "Configure the Network Parameters"
14
Operations Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VoIP V3 and is the answer not in the manual?

Table of Contents