Alarm Out - Sony DynaView SSC-CR441 Operating Instructions Manual

ALARM OUT

Select the mode of the ALARM OUT
function from ALARM or DAY/NIGHT.
The ALARM function can configure that
the ALARM OUT will be triggered by each
alarm input 1 - 4 detection or motion
detection. DURATION time can be set from
1 sec to 10 sec. The time defines the alarm
output endurance time.
The DAY/NIGHT function can configure
that the ALARM OUTPUT will be
triggered by the alarm from DAY/NIGHT
function. When DAY/NIGHT function is
set to on, the ALARM OUTPUT will
change its state at the time of switching
from the day mode to the night mode or
from the night mode to the day mode.
(Available for SSC-CR481.)
INPUT 1-4: The external sensor will be
connected to alarm input 1 to 4 of the
camera I/O port. Select ON to activate
ALARM OUT. Select OFF to ignore the
detection.
MOTION: Select ON to activate ALARM
OUT. Select OFF to ignore the detection.
DURATION: The alarm output endurance
time can be decided by DURATION (1 to
10 seconds).
Main menu → :SYSTEM: menu
→ :ALARM OUT: menu
Set Alarm Input
1
Press "95," and then hold the
PRESET key for 3 seconds to enter
the main menu screen.
2
Highlight :SYSTEM:, and then press
the OPEN key to enter the
:SYSTEM: menu.
3
Highlight :ALARM OUT:, and then
press the OPEN key to enter the
:ALARM OUT: menu.
4
Highlight the alarm INPUT or
MOTION, and configure its status for
detection (OFF or ON).
5
Press the OPEN key to confirm, or
press CLOSE to cancel selection and
exit from the menu screen.
Set Duration Time for Alarm
Out
1
Press "95," and then hold the
PRESET key for 3 seconds to enter
the main menu screen.
2
Highlight :SYSTEM:, and then press
the OPEN key to enter the
:SYSTEM: menu.
3
Highlight :ALARM OUT:, and then
press the OPEN key to enter the
:ALARM OUT: menu.
4
Highlight DURATION, and configure
duration time for alarm out.
5
Press the OPEN key to confirm, or
press CLOSE to cancel selection and
exit from the menu screen.
45
SYSTEM