Sony DynaView SSC-CR441 Operating Instructions Manual page 40

Color video camera
Table of Contents

Advertisement

threshold level of motion detection, so
that LOW has the strongest sensitivity.
The INTERVAL TIME item can be set
between 1 sec. and 120 sec.
The area indication stays on blinking for
interval time after the first motion
detection, and later detections will be
ignored in the term of interval time.
1
Press "95," and then hold the
PRESET key for 3 seconds to enter
the main menu screen.
2
Highlight :PRESET SETUP:, and
then press the OPEN key to enter the
:PRESET SETUP: menu.
3
Highlight :MOTION:, and then press
the OPEN key to enter the :MOTION:
menu.
4
Highlight PRESET POSITION, and
then press the OPEN key to enter.
5
Move the joystick up/down to choose
the desired preset position.
6
Press the OPEN key to confirm, or
press CLOSE to cancel selection and
exit.
7
Highlight LEVEL item or
INTERVAL TIME item, and then
press OPEN key to enter.
8
Move up/down to set ON or OFF for
each item's parameter, and press the
OPEN key to confirm or press
CLOSE to cancel selection and exit.
Tips
For :MOTION AREA SETUP:, refer to
MOTION DETECTION capture on
page 42.
40
PRESET SETUP
Notes
• For preset positions, it is available from
this PRESET SETUP's item, but it is
restricted only from position 1 to 10
areas, and not available about other preset
positions.
• If Preset Position Call has been registered
in POSITION AT ALARM of SYSTEM,
first detection will cause the preset call
and camera will move the position
immediately, so that first detection's
indicating will also be cancelled before
interval time termination.
• After the camera moves via a preset
position call or PAN/TILT/ZOOM
operations, etc., motion detection will
stop for a few seconds to prevent
incorrect detections. Alarm Out and
Preset Position Call will not be activated
during this time.
• When actions (such as a scan, tour, etc.)
are not being performed and motion
detective is active, the Stop command
("96" + PRESET) will stop the motion
detection function. After the camera
moves again (via a preset position call or
PAN/TILT operations, etc.), motion
detection will resume.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dynaview ssc-cr481

Table of Contents