Freeze Activity; Activate Tour/Scan - Sony DynaView SSC-CR441 Operating Instructions Manual

4
Highlight RECOVER TIME, and then
press the OPEN key to enter.
5
Move the joystick up/down to set the
time.
6
Press the OPEN key to confirm, or
press CLOSE to cancel selection and
exit from the menu screen.

FREEZE ACTIVITY

When the camera is in tour mode, frame
scan or random scan mode, the camera
screen can be disabled during movement,
and the screen image will only be shown
until the camera reaches the stop point.
Set Freeze Activity
1
Press "95," and then hold the
PRESET key for 3 seconds to enter
the main menu screen.
2
Highlight :PAN TILT SETUP:, and
then press the OPEN key to enter the
:PAN TILT SETUP: menu.
3
Highlight :TOUR & SCAN:, and then
press the OPEN key to enter the
:TOUR & SCAN: menu.
4
Highlight FREEZE ACTIVITY, and
then press the OPEN key to enter.
5
Move the joystick up/down to choose
ON or OFF.
6
Press the OPEN key to confirm, or
press CLOSE to cancel selection and
exit from the menu screen.

Activate TOUR/SCAN

PRESET TOUR and each scan functions
enables the user to select the status OFF,
ALWAYS, or SCHEDULE mode.
After selection of a tour or a scan mode, the
mode status is indicated.
OFF: No action after exit from menu
ALWAYS: Continuous single action will
start after exit from menu
SCHEDULE: Each action will be activated
on schedule after exit from menu
ALWAYS should be selected one action
from all of tours or scan mode. Stop
command ("96" + PRESET) is available
for going the action off.
SCHEDULE is available for tour A, B, C
and each scan mode.
After configuration on this page, each mode
is activated following SCHEDULE setup in
OTHERS menu.
Notes
• Tour D and E cannot be registered to
SCHEDULE.
• The action driven by the predefined
preset number will be forced to stop by
menu open operation, and it will not be
able to resume after menu close
operation. In this case, the camera starts
movement with reference to the
parameter of the STATUS in TOUR &
SCAN of menu.
• The action driven by the predefined
preset number is in priority to the
scheduled action, and it carries on until
the user stops the action expressly.
• The action scheduled in menu will be
activated preferentially when camera is
operated by the key pads. But after
starting the action, if the user continues
the operation of the key pads, the action
will stop and keep the status in
background.
Horizontal Pan/Vertical Tilt Setup
33