Mount Method; Installing The Camera On A Ceiling - Sony DynaView SSC-CR441 Operating Instructions Manual

Mount Method

Notes
• Do not grasp the camera head when
carrying the camera.
• Do not turn the camera head manually.
Doing so will likely result in the camera
malfunctioning.
• Turn off the power of the camera before
installing it.
• This unit is a hang-type indoor camera.
Avoid installing the camera at a lower
location, such as floor area, with its head
facing upward.
Install the camera to a horizontal place. If
you have to install the camera to an incline,
make sure the incline is within ±15° to the
horizontal level to ensure the turning
performance of the camera.
Installing the Camera on a
Ceiling
Use the supplied ceiling bracket to install
the camera. The ceiling bracket is attached
to the camera unit. Detach the ceiling
bracket before installing.
WARNING
• If you attach the camera in a high location
such as wall or ceiling, etc., entrust the
installation to an experienced contractor
or installer.
• If you install the camera in a high
location, ensure that the ceiling is strong
enough to withstand the weight of the
camera plus mounting brackets and
screws, and then install the camera
securely. If the ceiling is not strong
enough, the camera may fall and cause
serious injury.
• To prevent the camera from falling, make
sure to attach the built-in wire rope.
14
Mount Method
• If you attach the camera to the ceiling,
check periodically, at least once a year, to
ensure that the connection has not
loosened. If conditions warrant, make
this periodic check more frequently.
Before Installation
• Decide the direction in which the camera
will shoot, before making holes for
wiring and screw holes.
• Push down the perforated tab to bundle
the cables from the side of the camera.
(For details, see "0 Cable cover" in
"Location and Function of Part".)
Installing Directly on a Ceiling
Using the supplied template, make a hole
for the wiring (ø40 mm). Determine the
location of the three screw holes for
attaching the ceiling bracket.
ø130
Using the Existing Junction
Box
Attach the ceiling bracket to the junction
box. Screws for this operation are not
supplied.
Attach the ceiling bracket in a manner that
the triangular mark faces the front side of
the camera.
3-Screw hole
ø40
Cable hole
Unit: mm