Sony DynaView SSC-CR441 Operating Instructions Manual page 16

Align the triangular f mark on the
camera with the diamond-shaped ◊ mark
on the ceiling bracket.
4
Rotate the camera unit in a clockwise
direction.
5
Attach the camera unit to the ceiling
bracket by fixing two screws at both
sides of the unit.
6
Attach the cable cover.
16
Mount Method
Use the supplied screws to install the unit.
Using other screws may cause damage
inside the unit.
How to Remove the Camera
1
Ceiling bracket
2
Ceiling
3
Screw
(supplied)
Although you can disconnect the cables
while the camera unit is hanging from the
ceiling bracket with the help of the rope, be
sure not to put additional pressure on the
unit.
4
Always hold the camera when you
dismount the camera unit. This will prevent
any risk of the camera falling.
CAUTION
Loosen and remove the two screws on
both sides of the camera unit.
Rotate the camera unit in a
counterclockwise direction, and
remove it from the ceiling bracket.
Disconnect the cables.
Note
Unhook the built-in wire rope from
the ceiling bracket, and dismount the
camera unit.
Note