Table of Contents
Advertisement
Horizontal Pan/
Vertical Tilt Setup
Main menu → :PAN TILT SETUP:
menu
→ :TOUR & SCAN: → :OTHERS:
SCAN LIMIT STOPS
When the camera SCAN mode is set to
AUTO, FRAME, or RANDOM, once the
scan range is reached, the camera will turn
the other direction after STOP TIME.
Activate SCAN LIMIT STOPS
1
Press "95" + hold the PRESET key
for 3 seconds to enter the main menu
screen.
2
Highlight :PAN TILT SETUP:, and
then press the OPEN key to enter the
:PAN TILT SETUP: menu.
3
Highlight :TOUR & SCAN:, and then
press the OPEN key to enter the
:TOUR & SCAN: menu.
4
Highlight SCAN LIMIT STOPS, and
then press the OPEN key to enter.
32
Horizontal Pan/Vertical Tilt Setup
5
Move the joystick up/down to choose
ON or OFF.
6
Press the OPEN key to confirm, or
press CLOSE to cancel selection and
exit from the menu screen.
Set SCAN LIMIT STOPS
• Activate the scan range (SCAN LIMIT
STOPS = ON) and then exit the menu.
• Set the left limit: use the joystick and
move the camera to the left limit position.
Press number key "92" + hold the
PRESET key for 3 seconds. The screen
will show: SCAN LEFT LIMIT, and the
left limit will be set.
• Set the right limit: use the joystick and
move the camera to the right limit
position, then press number key "93" +
hold the PRESET key for 3 seconds. The
screen will show: SCAN RIGHT LIMIT,
and the right limit will be set.
RECOVER TIME
In tour and scan mode (auto, frame,
random), if it is interrupted by inadvertent
keypad controller input, the camera will
resume the previous action after a set
amount of time. The recovery time can be
set between 1 to 60 min.
Set the Recovery Time
1
Enter "95," and then hold the
PRESET key for 3 seconds to enter
the main menu screen.
2
Highlight :PAN TILT SETUP:, and
then press the OPEN key to enter the
:PAN TILT SETUP: menu.
3
Highlight :TOUR & SCAN:, and then
press the OPEN key to enter the
:TOUR & SCAN: menu.
Advertisement
Table of Contents
