Stabilizer - Sony DynaView SSC-CR441 Operating Instructions Manual

2
Highlight :PAN TILT SETUP:, and
then press the OPEN key to enter the
:PAN TILT SETUP: menu.
3
Highlight :OTHERS:, and then press
the OPEN key to enter the :OTHERS:
menu.
4
Highlight MANUAL LIMIT STOPS,
and then press the OPEN key to enter.
5
Move the joystick up/down to choose
ON or OFF.
6
Press the OPEN key to confirm, or
press CLOSE to cancel selection and
exit from the menu screen.
Set MANUAL LIMIT STOPS
1
Activate the manual scan range
(MANUAL LIMIT STOPS = ON)
and then exit the menu.
2
Set the left limit: use the joystick and
move the camera to the left limit
position, then press number key "90"
+ hold the PRESET key for 3
seconds. The screen will show:
MANUAL LEFT LIMIT, and the left
limit will be set.
3
Set the right limit: use the joystick and
move the camera to the right limit
position, then press number key "91"
+ hold the PRESET key for 3
seconds. The screen will show:
MANUAL RIGHT LIMIT, and the
right limit will be set.
Note
When MANUAL LIMIT STOPS is set to
ON, AUTO FLIP function will not be
available.
36
Horizontal Pan/Vertical Tilt Setup

STABILIZER

The stabilizer function will be effective to
stabilize the gentle vibration of the image.
This function employs digital zoom system
and the image angle will be cropped slightly
without deterioration of sensitivity.
(This function is limited in SSC-CR481.)
Note
If the camera has been operated by the
maximum speed or long time movement of
its pan/tilt, the image would not be
stabilized for a while in some cases.
1
Press "95," and then hold the
PRESET key for 3 seconds to enter
the main menu screen.
2
Highlight :PAN TILT SETUP:, and
then press the OPEN key to enter the
:PAN TILT SETUP: menu.
3
Highlight :OTHERS:, and then press
the OPEN key to enter the :OTHERS:
menu.
4
Highlight STABILIZER, and then
press the OPEN key to enter.
5
Move the joystick up/down to choose
on or off.
6
Press the OPEN key to confirm, or
press CLOSE to cancel selection and
exit from the menu screen.