Table of Contents
Advertisement
Random Scanning
Random scanning would be resumed if the
camera had been powered down in
RANDOM scan mode, or can be controlled
by the keypad controller (for details, see the
table on page 55). Configuring the zoom
level and tilt angle is the same as in auto
scanning.
When the scan range has not been
set
The camera will randomly pick a stop point
and perform scanning until a command
from the keypad controller is received (e.g.,
horizontal rotate, vertical rotate, iris, focus,
etc). Refer to the diagram below.
A
C
H
E
When the scan range has been set
The camera will randomly pick a stop point
and perform scanning in the set range until
a command from the keypad controller is
received (e.g., horizontal rotate, vertical
rotate, iris, focus, etc). Refer to the diagram
below.
G
B
D
F
left limit
Note
Please use the menu command <PAN TILT
SETUP / TOUR & SCAN> STOP TIME to
configure the stop time (5 sec to 120 sec).
right limit
23
Scan Function
Advertisement
Table of Contents
