Speed; Stop Time - Sony DynaView SSC-CR441 Operating Instructions Manual

• To stop the action scheduled in menu, it is
necessary to change the status OFF in this
item. Predefined preset command ("96" +
PRESET) is not available to stop the
action. Camera will stop at the moment,
but restart the action scheduled in menu.
1
Press "95," and then hold the
PRESET key for 3 seconds to enter
the main menu screen.
2
Highlight :PAN TILT SETUP:, and
then press the OPEN key to enter the
:PAN TILT SETUP: menu.
3
Highlight :TOUR & SCAN:, and then
press the OPEN key to enter the
:TOUR & SCAN: menu.
4
Highlight TOUR/SCAN, and then
press the OPEN key to enter.
5
Move the joystick up/down to choose
the desired preset tour A, B, C, D, E or
scan mode (FRAME/RANDOM/
AUTO).
6
Press the OPEN key to confirm, or
press CLOSE to cancel selection and
exit from this selection.
7
Highlight TOUR/SCAN STATUS,
and then press the OPEN key to enter.
8
Move the joystick up/down to set the
status OFF, ALWAYS or
SCHEDULE.
9
Press the OPEN key to confirm, or
press CLOSE to cancel selection and
exit from the menu screen.

SPEED

The patrol speed of tour A, B, C, D, E,
AUTO scan, RANDOM scan and FRAME
34
Horizontal Pan/Vertical Tilt Setup
scan can be set to a value from 1 to 24 steps.
The value of 24 is maximum pan speed
300°/s.
Set the tour/scan speed
1
Press "95," and then hold the
PRESET key for 3 seconds to enter
the main menu screen.
2
Highlight :PAN TILT SETUP:, and
then press the OPEN key to enter the
:PAN TILT SETUP: menu.
3
Highlight :TOUR & SCAN:, and then
press the OPEN key to enter the
:TOUR & SCAN: menu.
4
After confirmation of action mode,
highlight SPEED, and then press the
OPEN key to enter.
5
Move the joystick up/down to set the
speed.
6
Press the OPEN key to confirm, or
press CLOSE to cancel selection and
exit from the menu screen.

STOP TIME

In tour A, B, C, D, E, RANDOM and
FRAME scan modes, STOP TIME can be
set. During patrol, the camera will pause at
each stop position from 5 sec to 120 sec.
Set the Stop Time
1
Enter "95," and then hold the
PRESET key for 3 seconds to enter
the main menu screen.
2
Highlight :PAN TILT SETUP:, and
then press the OPEN key to enter the
:PAN TILT SETUP: menu.