Table of Contents
Advertisement
8
After configuration of the left top
position, the screen displays END
POSITION blinking.
Move the joystick up/down/left/right
to define the height and width of the
area.
Notes
• The item of MOTION DETECTION in
OHTERS menu chosen from top menu is
available for any positions but these four
areas will not be available when camera
is in movement, in scan actions
(involving each stop positions of
FRAME SCAN and RANDOM SCAN)
or camera is in the preset positions
defined.
• It is recommended that AUTO FLIP
function will be set to OFF for use in this
MOTION DETECTION. The MOTION
AREA will not be flipped when the
image is flipped by the function.
• After the camera moves via a preset
position call or PAN/TILT/ZOOM
operations, etc., motion detection will
stop for a few seconds to prevent
incorrect detections. Alarm Out and
Preset Position Call will not be activated
during this time.
• When actions (such as a scan, tour, etc.)
are not being performed and motion
detective is active, the Stop command
("96" + PRESET) will stop the motion
detection function. After the camera
moves again (via a preset position call or
PAN/TILT operations, etc.), motion
detection will resume.
SYSTEM
DATE & TIME
Main menu → :SYSTEM: menu
→ :DATE & TIME: menu
Set the Week
1
Press "95," and then hold the
PRESET key for 3 seconds to enter
the main menu screen.
2
Highlight :SYSTEM:, and then press
the OPEN key to enter the :SYSTEM:
menu.
3
Highlight :DATE & TIME:, and then
press the OPEN key to enter the
:DATE & TIME: menu.
4
Highlight WEEK, and then press the
OPEN key to enter.
5
Move the joystick up/down to set the
week.
6
Press the OPEN key to confirm, or
press CLOSE to cancel selection and
exit from the menu screen.
43
SYSTEM
Advertisement
Table of Contents
